(11) Install the new lockwasher (35), tighten the rod end (37) and adjust approximately to the dimension M recorded before. (12) Do not TORQUE and safety the nut (36) at this time. (13) Connect the rod ends (34) and (37) to the leg of the nose landing gear. (14) Make sure that the bush (39) is in position, install the washers (38), the bolt (40), the washer (28) and the nut (27). (15) Install the screw (22), the washer (23) and the nut (24). (16) Tighten the nuts (24) and (27) but do not TORQUE and safety them at this time. (17) Remove the nut (51) and the bolt (48). (18) Disconnect the rod end (47) from the leg door of the nose landing gear. (19) Measure and record the dimension L to help the adjustment. (20) Loosen the nut (46), remove the rod end (47), remove and discard the lockwasher (45). (21) Install the new lockwasher (45), tighten the rod end (47) and adjust approximately to the dimension L recorded before. (22) Tighten the nut (46) but do not TORQUE and safety it at this time. (23) Connect the rod end (47) to the leg door of the nose landing gear. (24) Make sure that the bushes (49) and (50) and the rod (43) are in position, install the bolt (48) and the nut (51). (25) Tighten the nut (51) but do not TORQUE and safety it at this time.
EFF : R CES
ALL
32-22-00
Page 519 May 01/03
飞行翻译公司 www.aviation.cn 本文链接地址：A319 A320 A321 飞机维护手册 AMM Aircraft Maintenance Manual 23_部分4.pdf
EFF : R CES
ALL
32-22-00
Page 519 May 01/03
飞行翻译公司 www.aviation.cn 本文链接地址：A319 A320 A321 飞机维护手册 AMM Aircraft Maintenance Manual 23_部分4.pdf
自定义标签： 
