1. What terms could a ATC furnishes pilots' braking action reports using? A. "good", "fair", "poor" and "nil" or a combination of these terms B. the percentage of the proximate braking action C. only use "good", "fair", "poor" and "nil" with no combination of these terms.
A X 2. The leading edge of an advancing warm air mass is. A. warm front B. stationary front C. cold front
A X 3. Which of the following characteristics heat thunderstorm? A. It moves with the weather system. B. It covers small area and is isolated with openings C. It strengthens at night and weakens in the day on land
B X 4. In a light, twinengine airplane with one engine inoperative, when is it acceptable to allow the ball of a slipskid indicator to be deflected outside the reference lines? A. While maneuvering at minimum controllable airspeed to avoid over banking. B. When operating at any airspeed greater than VMC. C. When practicing imminent stalls in a banked attitude.
B X 5. Which place in the turbojet engine is subjected to the highest temperature? A. Compressor discharge. B. Fuel sprays nozzles. C. Turbine inlet.
C X 6. Which speed symbol indicates the maximum speed for operating the landing gear of an airplane?
飞行翻译公司 www.aviation.cn 本文链接地址：988道题.doc
A X 2. The leading edge of an advancing warm air mass is. A. warm front B. stationary front C. cold front
A X 3. Which of the following characteristics heat thunderstorm? A. It moves with the weather system. B. It covers small area and is isolated with openings C. It strengthens at night and weakens in the day on land
B X 4. In a light, twinengine airplane with one engine inoperative, when is it acceptable to allow the ball of a slipskid indicator to be deflected outside the reference lines? A. While maneuvering at minimum controllable airspeed to avoid over banking. B. When operating at any airspeed greater than VMC. C. When practicing imminent stalls in a banked attitude.
B X 5. Which place in the turbojet engine is subjected to the highest temperature? A. Compressor discharge. B. Fuel sprays nozzles. C. Turbine inlet.
C X 6. Which speed symbol indicates the maximum speed for operating the landing gear of an airplane?
飞行翻译公司 www.aviation.cn 本文链接地址：988道题.doc
自定义标签： 
